E016
Siemens
Configuration / Parameter Error in Control Module
Oven displays E016, often after a power cut or surge, some functions locked
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted EEPROM settings, Incorrect configuration after board replacement, Power surge affecting memory
How to Fix / Troubleshooting
Safety: Disconnect power before handling electronics.
- Power reset: Turn off the oven at the breaker for at least 15 minutes to allow the control to fully discharge, then restore power.
- Factory reset (if available): Consult the Siemens user manual for a key combination to reset settings to factory defaults and perform it.
- Check model configuration: If the control board was recently replaced, verify that the correct Siemens part number was installed and that any required configuration procedure (jumper settings or service menu) has been completed.
- Service mode: Some models require a technician to reprogram the module using Siemens service tools. If E016 persists, professional service is recommended.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements