E019
Siemens
Cooling System Overrun / Sensor Error
Oven shows E019, fan may run continuously after cooking
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty temperature sensor near control panel, Cooling fan not reaching required speed, Blocked air channels around control area
How to Fix / Troubleshooting
Safety: Disconnect from mains before accessing internal components.
- Check fan operation: After cooking, the cooling fan should run and then stop once the oven cools. If E019 appears, verify that the fan is actually running and not obstructed.
- Clean air paths: Remove dust and grease from the fan blades and air channels using a soft brush and vacuum.
- Inspect sensor: Locate the small sensor or thermostat near the control panel area and check wiring for damage.
- Replace faulty parts: If the fan is slow or noisy, replace the cooling fan. If the sensor shows incorrect readings or open circuit, replace it with a Siemens-approved part.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Cooling Fan Assembly or Control Area Temperature Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements