E024
Siemens
Bottom Heating Element Fault
Oven shows E024, grill may work but bottom heat does not
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open-circuit lower heating element, Burnt connector at lower element, Wiring break between element and control board
How to Fix / Troubleshooting
Safety: Turn off power and verify isolation before working underneath or behind the oven.
- Check heating pattern: In conventional mode, if only the top area heats and E024 appears, the bottom element is likely faulty.
- Access element: Depending on model, remove the oven base panel inside the cavity or access from the rear to reach the lower element terminals.
- Test element: Disconnect the wires and measure resistance. An infinite reading indicates a failed element.
- Inspect connectors: Replace any overheated spade terminals and ensure a tight fit on the new element.
- Install replacement: Fit a Siemens lower heating element of the correct rating and reassemble all panels securely.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Lower Heating Element
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements