Teka Function Selector / Mode Switch Fault (for knob-based models)

Oven light works but fan and heating do not start when a function is selected.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Worn function selector switch, broken switch shaft, burned contacts inside selector, loose wiring on selector terminals

Safety first: Turn off power before removing the control panel or knobs.

Steps:

Pull off the function selector knob and remove the front panel to access the selector switch.
Inspect the switch body for cracks or signs of overheating.
Check that the shaft turns the internal cam; if the shaft is broken, replace the selector.
Test continuity across the appropriate switch contacts for each function using the wiring diagram. Replace the selector if contacts do not close correctly.
Reattach all wires according to the diagram and secure the switch firmly.

Medium 3/5

Function Selector Switch

Check Price on Amazon

We may earn a commission from links on this page.