Teka
Accessory Detection / Safety Logic Fault
Pyrolytic self-cleaning does not start; oven indicates that accessories or trays are still inside even when removed.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty cavity temperature sensor, misinterpreted door lock status, firmware logic issue, incorrect user settings
How to Fix / Troubleshooting
Safety first: Ensure the oven is empty and cool before attempting pyrolysis.
Steps:
- Remove all racks, trays, and side supports as required by the manual.
- Verify that the door closes and locks correctly; troubleshoot the door lock if necessary.
- Reset the oven by disconnecting power for several minutes, then reprogramming the clock.
- If the cycle still will not start, test the temperature sensor and safety thermostats; replace any faulty components.
- Persistent issues may require a control board firmware update or replacement by an authorized Teka service center.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements