Auger does not turn at all, but no error code is displayed; grill may still ignite from residual pellets.

Safety first: Turn OFF and unplug the grill. Empty the hopper before working on the auger.

• Check connector: Verify the auger motor plug is fully seated on the control board.
• Test motor directly: If you are qualified, disconnect the motor and power it briefly with the appropriate voltage from a test source to see if it turns. If not, the motor is bad.
• Inspect capacitor: Some AC auger motors use a start capacitor. Replace a bulging or leaking auger motor capacitor.
• Replace auger motor: Install a new Enders auger motor assembly if the old one does not run.
• Check board output: If a known-good motor does not run when connected, the control board auger output is likely faulty and the board should be replaced.