Er19
Enders
Controller EEPROM / Configuration Fault
Er19 appears; grill reports internal memory or configuration error.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted controller memory, Interrupted firmware update, Power surge during operation, Defective main control board
How to Fix / Troubleshooting
Safety first: Turn OFF and unplug the grill before servicing electronics.
- Power reset: Unplug the grill for at least 5 minutes to allow capacitors to discharge, then plug back in and restart.
- Factory reset: If supported, perform a factory reset of the controller following the Enders manual. This can clear corrupted settings.
- Firmware reflash: Use the official Enders method (USB, app, or service tool) to reinstall or update the firmware.
- Surge protection: Connect the grill through a quality surge protector to prevent future memory corruption from power spikes.
- Replace control board: If Er19 persists, replace the Enders main control board with a new, pre-programmed unit.
After replacement, verify all functions (ignition, feed, fan, probes) operate normally.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements