Enders Ignition Failure with Pellet Feed

Grill powers on but will not ignite; pellets feed into the fire pot but never light, causing a pile of unburned pellets.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Weak or burned-out igniter, Igniter not positioned correctly in fire pot, Excessive ash insulating pellets from igniter, Low combustion airflow

How to Fix / Troubleshooting

Safety first: Turn OFF and unplug the grill. Allow all pellets in the fire pot to cool completely before cleaning.

  • Clean fire pot: Remove all pellets and ash from the fire pot. Vacuum thoroughly so the igniter is exposed.
  • Check igniter position: The tip of the Enders glow igniter rod should protrude slightly into the fire pot holes or sit just below the pellet bed. Adjust mounting if it is too far back.
  • Test igniter glow: With the fire pot exposed, plug in the grill and start a cycle. Confirm the igniter glows bright red/orange within a few minutes. Replace if it does not.
  • Verify airflow: Ensure the combustion fan runs during ignition and that intake/exhaust paths are clear.
  • Restart: After cleaning and any replacement, follow the proper startup procedure and monitor the first ignition to confirm a stable flame.
Advertisements

Repair Difficulty

Medium 3/5

Required Part

Glow Igniter Rod (Hot Rod Assembly)
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements