Display shows "noP" or similar no‑pellet warning and grill shuts down

Safety first: Turn OFF and unplug the grill before reaching into the hopper.

• Refill hopper: If pellets are low or empty, fill the hopper with fresh, dry pellets.
• Break pellet bridges: Use a clean, dry tool or your hand (with grill unplugged) to stir pellets in the hopper and break up any clumped or bridged pellets that are not dropping into the auger intake.
• Check for obstructions: Inspect the hopper opening above the auger for foreign objects or compacted sawdust. Vacuum out fines if necessary.
• Prime the auger: If the auger ran empty, run a prime or feed cycle until pellets begin to fall into the fire pot, then stop the cycle and start a normal ignition.
• Inspect hopper sensor (if present): Some Nexgrill models use a simple level switch. Ensure its wiring is intact and the sensor is not stuck. Replace if it falsely reports empty when the hopper is full.