Heat Siphon
Overcurrent / Short Circuit
Unit frequently trips the circuit breaker when starting or during operation.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Shorted compressor windings, Failing fan motor, Shorted wiring to ground, Incorrect breaker size or wiring
How to Fix / Troubleshooting
Safety first: Do not repeatedly reset a breaker that trips immediately; this can be a fire hazard.
- Observe timing: Note whether the breaker trips immediately on start or after the unit has been running.
- Inspect wiring: With power off, check all visible wiring for insulation damage, burn marks, or loose connections.
- Isolate components: A technician can disconnect the compressor or fan motor to determine which component is causing the trip.
- Verify breaker and wire size: Ensure the breaker and wire gauge match Heat Siphon installation specs. Undersized wiring can overheat and trip.
- Component replacement: Replace any shorted motors or compressors as identified by a professional.
Advertisements
Repair Difficulty
Professional Required
5/5
Advertisements