SPGAS
SmartPool Gas supply fault

Display shows SPGAS; heater aborts ignition

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Manual gas valve closed, Gas line undersized for SmartPool heater BTU rating, Regulator failure, Air in gas line after service

How to Fix / Troubleshooting

Gas safety: If you smell gas continuously, shut off the gas supply and call your gas utility or a licensed technician immediately.

  • Verify gas valve: Ensure the external gas shutoff valve to the SmartPool heater is fully open (handle parallel to the pipe).
  • Check other gas appliances: See if other gas appliances (stove, furnace) are working. If not, there may be a supply issue.
  • Recent work: If gas piping was recently serviced, air may be in the line. Several ignition attempts may be needed, but do not repeatedly reset if SPGAS persists.
  • Do not adjust regulator: Gas pressure and regulator settings must be checked by a licensed gas technician using proper instruments.
Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

SmartPool Gas Regulator
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements