E09
Bestway
Internal Sensor / Hall or RPM Sensor Fault
Pump display shows E09 and the unit cycles on and off rapidly or fails to start.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed internal speed sensor on motor, Damaged sensor wiring harness, Faulty control PCB interpreting sensor signal, Strong electromagnetic interference nearby
How to Fix / Troubleshooting
Safety first: Unplug the pump before inspecting wiring or moving the unit.
- Relocate from interference: Ensure the pump is not placed directly adjacent to high‑power devices (large motors, welders, etc.) that could cause interference.
- Inspect wiring harness: On models with accessible motor connectors, check that all sensor and motor plugs are firmly seated and free of corrosion. Do not pull on wires; grasp connectors.
- Power reset: Leave the pump unplugged for 10–15 minutes to allow the control electronics to fully discharge, then reconnect and test.
- Service requirement: If E09 persists, the internal sensor or control board is likely defective. These components are not typically user‑serviceable and may require replacement of the motor assembly or PCB.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Bestway pump motor assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements