Pump trips the circuit breaker or RCD immediately when switched on.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Do not repeatedly reset a breaker that trips instantly. There may be a dangerous fault. Isolate power and keep the pump off until inspected.
Step-by-step checks (visual only):
- 1. Inspect cable and plug: Look for cuts, crushed sections, or burn marks on the Davey pump supply cable and plug.
- 2. Check motor for water: Look for obvious water inside the motor terminal box or around the cable entry gland.
- 3. Smell for burning: A strong burnt smell from the motor or controller indicates internal damage.
Electrical testing (insulation resistance, winding resistance) must be done by a licensed electrician or pump technician. In most cases, a motor or drive replacement is required.
Repair Difficulty
Required Part
We may earn a commission from links on this page.