Flowclear
No Power / Dead Unit
Pump will not start at all; no lights or display on the Flowclear control panel.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Tripped breaker or GFCI, Faulty power outlet, Damaged Flowclear power cord, Internal fuse blown on control PCB
How to Fix / Troubleshooting
Safety first: Do not open the pump while it is plugged in. Water and electricity are a dangerous combination.
Steps:
- 1. Check outlet and breaker: Test the outlet with another device. Reset any tripped breaker or GFCI. If it trips again immediately, stop and investigate for faults.
- 2. Inspect power cord: Look for cuts, abrasions, or crushed sections on the Flowclear cord. If damaged, the cord or entire pump should be replaced.
- 3. Try another outlet: Plug the pump into a different, known-good outlet (without extension cords) to rule out supply issues.
- 4. Internal fuse: If comfortable and allowed by the manual, open the control housing and check for a replaceable fuse on the PCB. Replace only with the same rating.
- 5. Replace control module: If the fuse is intact and there is still no power, the control PCB or motor assembly may have failed and should be replaced.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Flowclear Power Cord
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements