Display shows F1E4, oven may not start or may overheat.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Control board calibration data corrupted, Incorrect configuration, Sensor slightly out of spec, Power surge

Safety first: Disconnect power before removing panels.

Run temperature test: Use an accurate oven thermometer to compare actual temperature to set temperature at 350°F. If off by more than 35°F, calibration or repair is needed.
Sensor check: Test oven sensor resistance at room temperature; replace if out of spec.
Control calibration: Many Amana models allow temperature offset adjustment in the user menu. Adjust according to the user manual.
Replace control: If calibration cannot correct the issue and sensor is good, replace the control board.

Medium 3/5

Electronic Oven Control Board

Check Price on Amazon

We may earn a commission from links on this page.