F10
De Dietrich
Internal EEPROM / Configuration Error
Induction hob displays F10 and all zones are locked out.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware settings, Power surge damage to memory, Faulty main control board, Incorrect replacement board not coded for model
How to Fix / Troubleshooting
Safety: Isolate power before any internal work.
- Extended reset: Turn off the breaker for at least 15 minutes to fully discharge the electronics. Restore power and check if F10 clears.
- Check for recent work: If a control board was recently replaced, verify that the correct De Dietrich part number was installed and that any required configuration procedure was performed.
Note: F10 typically requires service-level tools to reprogram or replace the main control board. Contact an authorized De Dietrich service center.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements