Etna Open Convection Heating Element

Etna oven fan runs but there is no heat in convection mode.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Burnt-out circular convection element, Loose element terminals, Broken wiring between element and selector/control, Faulty convection relay

Safety: Disconnect power and allow the oven to cool before removing panels.

Access element: Remove the rear panel inside the oven cavity to expose the circular convection element.
Visual check: Look for breaks or burn marks on the element ring.
Continuity test: Measure resistance across the element terminals. An open circuit indicates a failed element.
Check connections: Tighten any loose terminals and inspect wiring for heat damage.
Replace element: Install a new Etna convection element if the original is open or damaged.

Medium 3/5

Convection Heating Element

Check Price on Amazon

We may earn a commission from links on this page.