Fagor
Configuration / Installation Error (Phase or Power Setting)
Fagor induction hob shows all displays flashing and beeping when power is turned on; no zones can be used.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect configuration of power limit, Wrong phase connection, Internal configuration not set after installation
How to Fix / Troubleshooting
Safety first: Disconnect the hob from mains before changing any wiring. Only qualified personnel should alter electrical connections.
- Check installation manual: Some Fagor hobs require initial configuration (power level or phase selection) at first startup. Follow the manual to enter configuration mode.
- Verify wiring bridges: At the terminal block, ensure the correct links are installed for single‑phase or two‑phase supply as specified.
- Reset configuration: Perform a factory reset or configuration reset if the manual provides a procedure.
- Service mode: If configuration cannot be completed or flashing persists, the control board may be faulty and require replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Terminal Block and Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements