Falcon Stuck Cooling Fan Control / Sensor Fault

Cooling fan at the top of the Falcon range runs continuously even when the oven is off and cool.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Stuck fan relay on control board, Faulty cavity temperature sensor reading hot, Shorted wiring to fan circuit

Safety first: Disconnect power before accessing the control panel.

Allow full cool-down: Ensure the oven has been off for several hours; some models keep the fan running until fully cool.
Test sensor: Check the cavity temperature sensor or thermostat for correct resistance at room temperature.
Inspect control board: If the sensor is good, the fan relay may be stuck closed; replace the EOC.

Continuous fan operation wastes energy and may indicate a deeper control fault.

Medium 3/5

Control Cavity Temperature Sensor

Check Price on Amazon

We may earn a commission from links on this page.