F70
Falcon
Warming Drawer Temperature Sensor / Heater Fault
Falcon range shows F70 and the warming drawer or storage drawer heater does not operate (on models with heated drawers).
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open warming drawer element, Failed drawer temperature sensor, Loose connector at drawer harness, Faulty drawer control PCB
How to Fix / Troubleshooting
Safety first: Turn off power at the mains before removing the drawer.
- Remove drawer: Pull the warming drawer out fully and lift to disengage from runners (refer to Falcon manual). Disconnect any electrical connectors carefully.
- Test element: Measure resistance across the drawer heater terminals. An open circuit indicates a failed element; replace the heater assembly.
- Check sensor: Locate the small NTC sensor in the drawer cavity and test its resistance. Replace if open or shorted.
- Inspect harness: Check for pinched or broken wires where the drawer slides in and out.
If all components test good, the main control or dedicated drawer PCB may be faulty and should be replaced.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Warming Drawer Heater Element
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements