F13
Frigidaire
EEPROM / Control Board Data Error
F13 error displayed, oven functions may be disabled or behave erratically.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted EEPROM on electronic oven control, Power surge damage, Internal control board failure, Loose control board connectors
How to Fix / Troubleshooting
Safety first: Disconnect power at the breaker before accessing internal components.
- Power cycle: Turn breaker OFF for 10 minutes to allow the control to fully discharge. Restore power and check if F13 clears.
- Inspect control connections:
- Remove the control panel/backguard to access the electronic oven control (EOC).
- Check all wire harness connectors to the EOC for tight fit and corrosion.
- Reseat connectors one at a time.
- Check for visible damage:
- Look for burnt components, cracked solder joints, or moisture on the control board.
- Replace control board: If F13 persists after reset and connections are secure, the EOC’s memory is likely corrupted and the electronic oven control must be replaced.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Oven Control (EOC) Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements