E9
Glem Gas
Internal Configuration / EEPROM Error
Cooktop shows E9 and beeps, all zones disabled
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware on main control board, Failed EEPROM memory, Incorrect replacement control board not programmed for model, Voltage spike damage
How to Fix / Troubleshooting
Safety first: Disconnect power before removing the control panel or boards.
- Power cycle: Turn off power for 10–15 minutes and restore. If E9 returns immediately, configuration memory is likely corrupted.
- Check model compatibility: If a control board was recently replaced, verify that the installed board is the correct Glem Gas part number for your exact model.
- Inspect for surge damage: Look for burn marks or damaged components on the main control board. If present, the board must be replaced.
- Board replacement: E9 faults usually require replacement of the main control board. Programming or configuration may need to be done by an authorized service center with access to Glem Gas service tools.
- Surge protection: After repair, consider using a surge protector or ensuring proper grounding to reduce future risk.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements