F1
Glem Gas
Electronic Oven Control Failure
Oven display shows F1 and beeps continuously until power is removed
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Internal failure of clock/timer module, Shorted control relay, Overheated control board, Voltage surge damage
How to Fix / Troubleshooting
Safety first: Turn off power at the breaker before accessing the control panel.
- Reset control: Disconnect power for 5–10 minutes, then restore. If F1 returns immediately, the control is likely defective.
- Check for overheating: Remove the control panel and inspect the electronic oven control (EOC) for burn marks, melted relay housings, or discolored areas.
- Inspect wiring: Ensure that no wires are shorted to the chassis and that all connectors are firmly seated.
- Replace EOC: If visible damage is present or F1 persists after reset, replace the electronic oven control with the correct Glem Gas part. Transfer the overlay if separate.
- Verify operation: After replacement, test all oven functions (bake, grill, fan) and temperature settings.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Oven Control (Clock/Timer)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements