F6
Hansa
Convection Fan or Fan Element Fault
F6 error on oven display, fan-assisted modes not working properly
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed convection fan motor, Open fan heating element, Obstructed fan blades, Faulty selector switch or relay
How to Fix / Troubleshooting
Safety first: Disconnect power and allow the oven to cool.
- Check fan operation: In a fan-only or fan-assisted mode, listen for the convection fan. If silent, the motor may be faulty.
- Inspect fan blades: Remove the rear panel inside the oven cavity to access the fan. Clean off grease and debris. Ensure the blades spin freely by hand.
- Test motor and element: From the rear of the appliance, test the convection fan motor and fan element for continuity.
- Selector / relay: Verify that the function selector switch sends power to the fan and element in the correct modes, or that the PCB relay operates.
- Replace components: Replace the Hansa convection fan motor or fan heating element if open or seized.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Convection Fan Motor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements