F0E8
Ikea
Cooktop Configuration or Calibration Error
Induction cooktop displays F0E8 and does not heat
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect configuration data in control board, Firmware corruption, Replacement board not programmed for model
How to Fix / Troubleshooting
Safety first: Disconnect power before accessing internal components.
- Power cycle: Turn off the breaker for 10 minutes to allow the control to fully reset, then restore power.
- Check model configuration: If a control board was recently replaced, verify that the correct Ikea/Whirlpool part number was installed and that any required configuration steps (jumper settings or programming) were performed per service manual.
- Reprogram or replace board: Some models require a technician to program the board with model-specific data. Contact service if F0E8 persists.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Cooktop Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements