F95
Insignia
EOC Internal Temperature or Processor Fault
Display shows F95 and oven may not respond to temperature changes or may shut down.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Overheated control board, Failed EOC processor, Blocked control cooling vents, Power surge damage
How to Fix / Troubleshooting
Safety first: Disconnect power at the breaker before accessing the control console.
- Allow cooling: If the error occurred after extended high-temperature use, allow the range to cool and ensure adequate ventilation around the control area.
- Inspect vents: Make sure the rear and top vents near the control panel are not blocked by cabinetry or objects.
- Check for board damage: Remove the console cover and inspect the EOC for signs of overheating or component failure. Replace the EOC if any damage is visible.
- Replace EOC: If F95 recurs after a power reset and ventilation is adequate, the EOC is likely defective and should be replaced.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Oven Control (EOC) Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements