F1E0
JennAir
Internal Oven Control Board Error
JennAir range shows F1E0; oven functions disabled
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control firmware, Failed microprocessor on control, Power surge damage, Overheated control board
How to Fix / Troubleshooting
Safety: Disconnect power before removing the control panel.
- Power cycle: Turn off the breaker for 10–15 minutes, then restore power. If F1E0 returns immediately, the control is likely bad.
- Check for overheating: Ensure vents around the control panel are not blocked and that the cooling fan (if equipped) is operating.
- Inspect control board: Remove the back cover and inspect the control for burnt components or discoloration. Any visible damage indicates replacement is needed.
- Replace control: Install a new JennAir-compatible electronic oven control board, transferring wires one at a time to avoid miswiring.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Oven Control Board (EOC)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements