F9-1
JennAir
Door Latch Not Engaging
JennAir range displays F9-1; oven door will not lock for self-clean
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Misaligned door latch, Weak door lock motor, Bent latch strike on door, Obstruction in latch mechanism
How to Fix / Troubleshooting
Safety: Turn off power before adjusting mechanical parts.
- Check door closure: Ensure the door closes fully and evenly. Replace bent hinges or adjust if the door sags.
- Inspect latch strike: Examine the metal strike on the door that engages the latch. If bent, carefully straighten or replace.
- Clean latch area: Remove any grease or debris around the latch opening that could prevent full engagement.
- Test lock motor: Start a self-clean cycle and listen for the lock motor. If it runs but cannot fully engage, the latch may be misaligned. If it does not run at all, the motor may be faulty.
- Replace latch assembly: Access the latch from the top or rear, remove mounting screws, disconnect wiring, and install a new JennAir-compatible latch/lock assembly.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Oven Door Latch / Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements