Display shows F93, self-clean will not start

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Weak lock motor, High friction in latch mechanism, Faulty lock position feedback switch, EOC logic fault

Safety first: Turn off power before accessing internal components.

Verify door alignment: Ensure the door is not sagging and that hinges are secure.
Inspect lock assembly: Access the lock motor and linkage. Clean any heavy grease or debris and ensure smooth movement.
Test motor and switch: Use a multimeter to verify motor windings and switch operation. Replace the lock assembly if defective.
Replace EOC if needed: If the lock assembly is good but F93 persists, the control board may be at fault.

Hard 4/5

Oven Door Lock Assembly

Check Price on Amazon

We may earn a commission from links on this page.