Electric range oven displays F1 and may beep continuously; oven may shut off.

Safety first: Disconnect power at the breaker before removing any panels or pulling the range out.

• Power reset: Turn off the breaker for 5 minutes, then restore power. If F1 returns immediately, proceed with checks.
• Inspect oven sensor:
  • Locate the temperature sensor probe inside the oven (usually on rear wall, upper area).
  • Ensure it is firmly mounted and not physically damaged.
• Check connections (advanced):
  • Pull the range forward and remove the rear panel.
  • Locate the sensor connector on the main control board and ensure it is fully seated.

If the sensor and wiring appear intact, the sensor should be tested with a meter and replaced if out of specification. If a new sensor does not clear F1, the EOC (main oven control board) is likely defective and should be replaced.