New World
Power Supply / Clock Module Fault
Digital display flickers, dims, or goes blank intermittently
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Loose neutral at terminal block, failing internal power supply on clock, cracked solder joints, heat damage from above
How to Fix / Troubleshooting
Safety: Isolate from mains before accessing the terminal block or control panel.
- Check mains connections: Inspect the rear terminal block for loose or burnt connections. Tighten and replace damaged parts as needed.
- Inspect clock module: Remove the control panel and examine the clock PCB for heat damage or cracked solder joints, especially around large components.
- Cooling: Ensure the cooling fan is working and vents are clear to prevent overheating of the electronics.
- Replace clock: If the display continues to flicker despite good supply and cooling, replace the electronic clock/programmer.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Electronic Clock/Programmer
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements