Premier
Weak Hot Surface Igniter
Gas oven igniter glows but burner does not light, or lights only after a long delay; oven temperature is low.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Igniter aged and drawing insufficient current, High resistance in igniter wiring, Failing oven gas safety valve, Contaminated burner ports restricting gas flow
How to Fix / Troubleshooting
Safety First: Turn off gas and power before removing the burner or igniter. Use caution when working around sharp metal edges.
Step-by-step:
- Observe behavior: Start a bake cycle and watch the igniter. If it glows for more than 60–90 seconds before the burner lights, or never lights, the igniter is likely weak.
- Clean burner: Turn off gas and power. Remove the bake burner and clean the ports with a soft brush or toothpick to clear any blockages.
- Replace igniter: Disconnect the old igniter from its harness, remove mounting screws, and install a new bake igniter rated for your Premier model. Do not touch the new igniter element with bare fingers.
- Inspect gas valve: If a new igniter does not correct the issue, the oven gas safety valve may not be opening properly and should be tested or replaced by a qualified technician.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements