Induction hob displays E7 and one or more zones are disabled.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Isolate the hob from mains before any work.
- Power reset: Turn off at the breaker for 10–15 minutes to allow full discharge, then restore power.
- Surge protection: If E7 occurred after a storm or outage, consider installing a surge protector on the circuit.
When to call a technician: E7 typically requires reprogramming or replacing the control board with the correct Teka firmware. This must be done by an authorized service technician.
Repair Difficulty
Required Part
We may earn a commission from links on this page.