How to Fix / Troubleshooting

Safety first: Disconnect mains power before working at the rear of the appliance.

Step-by-step:

Access condenser fan: Pull the fridge away from the wall. Remove the lower rear cover to expose the condenser coil and fan.
Clean area: Use a vacuum and soft brush to remove dust from the condenser and fan blades. Blocked airflow can cause overheating and errors.
Check fan movement: Spin the fan by hand. It should rotate freely without scraping.
Inspect wiring: Ensure the fan connector is firmly seated and wires are not cut or pinched.
Test operation: Briefly plug in the fridge and observe if the fan starts when the compressor runs (keep fingers clear). Then unplug again.
Replace fan: If the fan does not run or is noisy despite clean blades and good wiring, replace the condenser fan motor with a compatible Beko part.

Note: Running the fridge without a working condenser fan can damage the compressor; do not ignore this fault.

Display shows E10 and the refrigerator may not cool properly; often associated with fan or air circulation issues.

Possible Causes