Display shows E11 and the water dispenser or ice maker may not function correctly

Safety: Unplug the refrigerator and close the water supply valve before working on the water system.

Steps to address E11:

• 1. Check water supply: Ensure the household shutoff valve is fully open and water pressure is adequate. Straighten any kinked supply lines.
• 2. Inspect inlet valve: Access the rear lower area where the water line enters the fridge. Check for leaks, corrosion, or damaged coils on the valve.
• 3. Clean inlet screen: Turn off water, disconnect the supply line, and inspect the valve screen for debris. Clean gently if clogged.
• 4. Test valve coils: With power disconnected, measure resistance across each coil. An open circuit indicates a failed coil that requires valve replacement.
• 5. Flow sensor (if equipped): Some models use a flow meter. Inspect its wiring and ensure it is not blocked. Replace if defective.
• 6. Reassemble and test: Restore water and power, then test dispenser/ice maker. If E11 persists, the control board or sensor circuit may be faulty and require professional service.

Warning: Always check for leaks after working on water connections.