Display shows E6 and the ice maker or water dispenser may not function correctly.

Safety: Unplug the refrigerator and shut off the household water supply to the refrigerator before working on ice or water components.

Steps:

• Inspect door harness: At the bottom hinge of the freezer door (on side-by-side models), gently pull back the boot or cover and inspect the wire harness for breaks or pinched wires. Repair or replace as needed.
• Check ice maker connections: Remove the ice bucket and inspect the ice maker module. Ensure the multi-pin connector is fully seated.
• Dispenser control: On models with a dispenser control board in the freezer door, remove the dispenser trim and check the board connections for corrosion or looseness.
• Reset power: After reseating connectors, restore power and see if the E6 code clears.
• Replace failed module: If wiring is intact but the code persists and the ice maker/dispenser is non-functional, replace the ice maker assembly or dispenser control board with Crosley-compatible parts.