Error EA on display; water dispenser does not operate or stops mid-flow.

Safety first: Unplug the refrigerator and close the water supply valve before disconnecting any water lines.

Steps:

• 1. Check water supply: Ensure the household shutoff valve is fully open and the supply hose is not kinked.
• 2. Replace or bypass the water filter: A clogged filter can trigger flow errors. Install a new genuine De Dietrich filter or temporarily bypass to test.
• 3. Access the water inlet valve: Usually located at the rear bottom of the refrigerator. Remove the rear cover to expose it.
• 4. Test valve coils: Disconnect the electrical connectors and measure coil resistance. Open or shorted coils indicate a bad valve.
• 5. Inspect the flow sensor: Some models integrate a flow meter in the valve assembly or filter head. Check for stuck turbine or damaged wiring.
• 6. Replace faulty components: Install a new water inlet valve or filter head/flow sensor assembly as required. Use new seals and tighten fittings securely, then check for leaks.
• 7. Restore water and power: Turn on the water, plug in the unit, and purge air from the system by dispensing water for several minutes.