Refrigerator displays E07 and may not respond correctly to temperature adjustments; user interface may freeze or behave erratically.

Safety: Disconnect power before removing the control panel or display assembly.

Troubleshooting steps:

• 1. Power reset: Unplug the refrigerator for 5–10 minutes. Restore power and check if E07 clears. If it returns, proceed.
• 2. Inspect the control panel: Remove the trim around the display (often at the top of the refrigerator compartment or on the door) according to your model's instructions. Carefully pull the user interface forward.
• 3. Check connectors: Verify that the ribbon cable or harness between the user interface and the main control is fully seated and not damaged. Reseat the connector on both ends if accessible.
• 4. Look for moisture: Condensation or spills can enter the control area. If moisture is present, allow the panel to dry completely before reassembly.
• 5. Replace the user interface: If the cable is intact but E07 persists and the display behaves erratically, replace the user interface module with the correct Gaggenau part.
• 6. Consider main board: If a new UI does not resolve the error, the main control board may have a communication fault and should be replaced by a technician.

Tip: Handle ribbon cables gently and avoid bending them sharply to prevent damage.