88
GE Appliances
Control Panel Self-Test / Display Failure
Display shows 88 or all 8s and the control panel is unresponsive or stuck.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Control panel in demo or test mode, Stuck keypad, Faulty display board, Loose ribbon cable between display and main board
How to Fix / Troubleshooting
Safety first: Unplug the refrigerator before removing the control panel or display.
- Attempt a reset: Disconnect power for 5 minutes, then restore. Sometimes the 88 display is part of a self-test that will clear on its own.
- Exit demo/test mode: Press and hold the appropriate button combination (varies by model, often Energy Saver + Alarm or similar) for 3–5 seconds to exit demo mode.
- Inspect control panel connections: Remove the front control panel (usually snaps off or is held by a few screws). Check the ribbon cable and connectors for secure fit and no corrosion.
- Replace display/control panel: If the panel remains unresponsive or stuck on 88, the display board or touch panel is likely defective and should be replaced with the correct GE part.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
User Interface / Display Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements