E14
Gorenje
Real-Time Clock or EEPROM Error on Main PCB
Display shows E14; refrigerator may run continuously or not start defrost cycles correctly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted EEPROM data, Failed real-time clock circuit, Power surge damage to memory components
How to Fix / Troubleshooting
Safety: Unplug the refrigerator before accessing the main control board. Electronic component-level repair is not recommended for untrained persons.
Steps:
- Power reset: Disconnect power for at least 15 minutes to allow capacitors to discharge and the control to fully reset. Reconnect and observe if E14 returns.
- Check for surge protectors: If the unit is connected through a faulty surge protector or extension cord, plug it directly into a properly grounded wall outlet.
- Inspect the PCB: Remove the control cover and visually inspect the board for burnt or cracked ICs near the memory/clock area.
- Board replacement: If E14 persists after reset and there is no visible wiring issue, the main PCB likely needs replacement. Order the exact Gorenje board for your model and swap it carefully, moving one connector at a time.
- Test: Restore power, set the desired temperatures, and monitor operation for 24 hours to ensure normal cycling and no recurrence of E14.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board (PCB)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements