Display shows E10 and the water dispenser or ice maker may not function correctly.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Unplug the refrigerator and shut off the household water supply before disconnecting any water lines.
Steps:
- Verify that the household water supply valve is fully open and that the supply hose is not kinked.
- Replace the water filter if it is older than the recommended interval or appears clogged.
- Access the rear lower panel to locate the water inlet valve assembly.
- Check electrical connectors on the valve for secure fit.
- Measure coil resistance; an open coil indicates a failed valve.
Corrective action: Replace the water inlet valve assembly if a coil is open or the valve is mechanically stuck. If the valve and filter are good but E10 persists, the main control board or flow sensor may be at fault.
Repair Difficulty
Required Part
We may earn a commission from links on this page.