IceKing
Compressor Start Failure
Interior light on but compressor and fans do not run, clicking sound from rear every few minutes.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Weak compressor start relay/PTC, Failing compressor drawing high current, Overheating overload protector opening, Low mains voltage
How to Fix / Troubleshooting
Safety warning: Unplug the refrigerator before touching the compressor or electrical components.
Steps:
- 1. Listen for pattern: A repeating click every few minutes often indicates the overload protector opening due to failed starts.
- 2. Replace start relay/PTC: Access the compressor compartment, remove the start relay/PTC, and install a new IceKing-compatible relay. This is a common failure point.
- 3. Test again: Restore power and observe. If the compressor now starts and runs smoothly, monitor temperatures.
- 4. Compressor evaluation: If the new relay does not help and the compressor still fails to start, the compressor itself may be mechanically locked or electrically failing, requiring professional replacement.
Note: Do not repeatedly power-cycle a compressor that fails to start; this can cause further damage.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Compressor Start Relay / PTC
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements