Display shows E0 02, ice maker may overfill or leak into the bin.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Sticking water inlet valve, Ice maker fill sensor failure, Incorrect water pressure (too high), Ice maker control module fault

Safety First: Shut off the water supply and unplug the refrigerator before servicing.

Steps:

Inspect ice maker: Check for cracks in the ice mold or housing that could misdirect water.
Check valve operation: If water continues to drip into the ice maker when not calling for fill, the valve is sticking and must be replaced.
Verify pressure: If household pressure is very high, install a pressure regulator.
If the valve is good but overfill continues, replace the ice maker assembly which contains the fill control.

Medium 3/5

Ice Maker Assembly

Check Price on Amazon

We may earn a commission from links on this page.