E018
Ambrogio
Firmware / EEPROM Configuration Error
Robot displays E018 and stops, often after firmware update or power surge
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware, Interrupted firmware update, Faulty EEPROM memory, Main board failure
How to Fix / Troubleshooting
Safety first: Ensure the robot is OFF and on a stable surface.
- Power cycle: Turn the main switch OFF for 60 seconds, then ON again and check if E018 clears.
- Restore factory settings: If the menu is accessible, perform a factory reset as described in the Ambrogio manual (note: this may erase custom settings).
- Reflash firmware: Using the official Ambrogio service tool or USB update method, reload the correct firmware for your model. Follow manufacturer instructions carefully.
- If E018 persists: The EEPROM or main control board is likely defective and must be replaced.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements