Display shows E007 and mower refuses to start mowing cycle

Safety: Unplug the charging station from mains before handling boundary wires.

• Check LED on charging station: On Bosch Indego stations, a steady or flashing LED indicates boundary status. Refer to the manual for LED meaning; if off, check power supply.
• Inspect boundary wire connections: Ensure both ends of the loop are firmly inserted into the station terminals and that the insulation is stripped correctly.
• Walk the perimeter: Look for visible cuts, damage from gardening tools, or rodent bites. Pay special attention to path crossings and edges.
• Use a wire break locator or multimeter: Measure continuity of the loop from the station. A high resistance or open circuit indicates a break that must be repaired with Bosch-compatible boundary wire connectors.
• If the loop is intact: The charging station PCB or its transmitter coil may be defective and require replacement.