How to Fix / Troubleshooting

Safety: No special hazards.

Steps:

Verify compatibility: Confirm your Bagotte model supports magnetic strips or virtual walls.
Correct placement: Lay magnetic strips flat on the floor with the correct side up as per the manual.
Test with short strip: Place a short strip in front of the robot and start cleaning to see if it stops or turns away.
Clean front sensors: Wipe the front and underside sensors that may detect the strip.
If still ignored: The boundary detection sensor (often integrated with cliff or floor sensors) or firmware may be at fault. Sensor module or main board replacement may be required.

Robot vacuum does not detect or avoid virtual walls or magnetic boundary strips (if supported).

Possible Causes