E8
Ecovacs
Internal Communication / MCU Error
Robot vacuum reports E8 and stops; may indicate internal communication or main board error.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Firmware corruption, Main board failure, Loose internal connectors, Severe static or surge damage
How to Fix / Troubleshooting
Safety first: Turn the robot OFF.
- Power reset: Leave the robot off for 5 minutes, then power it back on.
- Firmware update: Use the Ecovacs app to check for and install firmware updates.
If E8 persists: The main control board likely needs replacement; contact Ecovacs support.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements