Robot vacuum leaves streaks or wet patches and does not mop evenly on mopping-capable models.

Safety: Turn OFF the robot and remove the water tank before handling water.

• 1. Clean or replace mop cloth:
  • Remove the mop pad and wash it thoroughly.
  • Replace if it is worn or hardened.
• 2. Check water outlets:
  • Inspect the water tank outlets and ensure they are not clogged.
  • Use a pin or soft brush to gently clear any blockage.
• 3. Remove airlocks:
  • Fill the tank, then gently tap it to release trapped air bubbles.
• 4. Reinstall correctly:
  • Attach the mop pad evenly to the plate and ensure the tank clicks into place.
• 5. Test on small area:
  • Run a short mopping cycle and check for even moisture distribution.