E13
Yeedi
Thermal Overload of Fan or Main Board
Robot vacuum announces E13 and stops; often associated with over-temperature protection, especially after long runs or blocked airflow.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Airflow blocked by clogged filters, Robot operating in very hot environment, Fan motor overheating, Main board heat sink obstructed by dust
How to Fix / Troubleshooting
Safety first: Turn the robot OFF and let it cool.
- 1. Allow cooling time: Leave the robot powered OFF for at least 30 minutes in a cool, shaded area.
- 2. Clean filters and airflow path: Remove the dustbin, clean or replace filters, and clear any dust buildup around the fan intake and exhaust vents.
- 3. Check environment: Avoid running the robot in rooms above 30–35°C (86–95°F) or in direct sunlight for extended periods.
- 4. Internal dust removal (advanced): Open the robot and gently blow out dust from the fan housing and main board using compressed air (short bursts, from a distance).
- 5. Test again: After cleaning and cooling, run a short cleaning cycle. If E13 recurs quickly, the fan motor or thermal sensor on the main board may be faulty and require replacement.
Warning: Do not block the robot's vents or operate it under blankets, curtains, or furniture skirts that restrict airflow.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Vacuum Fan Motor Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements