A-iPower Control Panel Power / Display Failure

Control panel display is blank or intermittent, but the generator may still run or crank.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Blown control fuse, Loose display connector, Failed display module, Low control voltage from charger

How to Fix / Troubleshooting

Safety first: Turn OFF the generator and disconnect the battery before opening the control panel.

  • Check control fuses: Locate and test the low-voltage control fuses in the panel. Replace any blown fuses with the correct rating.
  • Inspect display cable: Ensure the ribbon cable or harness between the controller and display is firmly seated.
  • Measure control voltage: Verify that the controller is receiving the correct DC supply from the charger/battery.
  • Replace display module: If power is present but the display remains blank, the display module may need replacement with an A-iPower-compatible part.
Advertisements

Repair Difficulty

Medium 3/5

Required Part

Controller Display Module
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements